LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2009 >> Commander Overland, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 25 (Electronic Control Modules (Service Information)) >> Electronic Control Modules >> Standard Procedure >> SKREEM Programming >> ECM/Skim/WCM Programming >> Notes

ECM/Skim/WCM Programming: Notes

WARNING: This page is about a different car, the 2008 Jeep Commander. However, it is still accessible from the selected car via links, so may be relevant.

When a ECM and the SKIM are replaced at the same time perform the following steps in order:

  1. Program the new SKIM
  2. Program the new ECM
  3. Replace all ignition keys and program them to the new SKIM.

When an ECM (Bosch) and the SKIM are replaced at the same time perform the following steps in order:

  1. Program the new SKIM
  2. Program the new ECM (Bosch)
  3. Replace all ignition keys and program them to the new SKIM.
scientia non olet · About LEMON Manuals