LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2009 >> Commander Overland, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 25 (Electronic Control Modules (Service Information)) >> Electronic Control Modules >> Module-Final Drive Control >> Operation >> Final Drive Control Module >> Transfer Case Mode Sensor Signal

Transfer Case Mode Sensor Signal

WARNING: This page is about a different car, the 2008 Jeep Commander. However, it is still accessible from the selected car via links, so may be relevant.

The Transfer Case Mode Sensor Signal Input will provide the FDCM feedback about the position of the transfer case. The mode sensor will be a linear analog position sensor with a 1.4K +/- 20% potentiometer and a 1 K +/- 20% wiper resistor that converts the motor shaft position into a multiplexed voltage.

scientia non olet · About LEMON Manuals