LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2009 >> Commander Overland, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 25 (Electronic Control Modules (Service Information)) >> Electronic Control Modules >> Module-Final Drive Control >> Installation >> Final Drive Control Module

Final Drive Control Module

WARNING: This page is about a different car, the 2008 Jeep Commander. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Removing/Installing Module Electrical Connector
GC0027611Courtesy of CHRYSLER LLC
  1. Place the final drive control module (3) in its location on the mounting plate (2) and firmly snap into place.
  2. Connect the electrical connector (1).
    Fig 2: Identifying Rear Seat Back Lower Anchors
    GC0027612Courtesy of CHRYSLER LLC
  3. Lower the rear seat back down into position.
  4. Connect the battery negative cable.
scientia non olet · About LEMON Manuals