LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2009 >> Commander Overland, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 25 (Electronic Control Modules (Service Information)) >> Electronic Control Modules >> Module-Adjustable Pedals >> Installation >> Adjustable Pedals Module

Adjustable Pedals Module

WARNING: This page is about a different car, the 2008 Jeep Commander. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: The Adjustable Pedals Module mounting tabs can be damaged during module installation. Use care to properly align tabs to prevent binding that could result in tab breakage.
Fig 1: Memory Seat Module - Removal/Installation
GC0027607Courtesy of CHRYSLER LLC
  1. Place the module (4) into position making sure the mounting tabs are properly aligned with the front bracket.
  2. Push down on the rear of the module (4) snapping the retaining clips into place in the side brackets.
  3. Connect the adjustable pedals module rear harness connectors (1).
  4. Connect the adjustable pedals module front harness connectors.
  5. Install the driver seat cushion/cover (2). Refer to INSTALLATION .
  6. Connect the battery negative cable.
  7. Verify system and vehicle operation.
scientia non olet · About LEMON Manuals