Transfer Case - NV245

WARNING: This page is about a different variant/trim than selected.

Fig 1: Rear Output Shaft Nut Removal/Installation

Courtesy of CHRYSLER LLC

1 - HOLDER C-3281

2 - REAR COMPANION FLANGE

Remove the rear propeller shaft. Refer to REMOVAL .
Using Holder C-3281 (1), remove the rear companion flange (2) nut. See Fig 1.

Fig 2: Rear Output Shaft Flange Removal/Installation
Courtesy of CHRYSLER LLC

1 - REAR COMPANION FLANGE

2 - OUTPUT SHAFT
Remove the rear output shaft flange (1) from the output shaft (2). If necessary, use a suitable 2 or 3 jaw puller to remove the output shaft flange. See Fig 2.
Remove the rear output shaft seal with a suitable pry tool or a screw mounted in a slide hammer.