Fluid Drain/Refill
WARNING: This page is about a different variant/trim than selected.
| 1 - BOLTS |
| 2 - DAMPER |
| 3 - REAR HOUSING |
- Raise vehicle.
- Remove the bolts (1) holding the damper (2) to the rear case (3). See Figure.
1 - DAMPER 2 - REAR HOUSING - Remove the damper (1) from the rear case (2). See Figure.
1 - I.D. TAG 2 - FILL PLUG 3 - DRAIN PLUG NOTE: The fill (2) and drain (3) plugs are both in the rear case. See Fig 3. - Position drain pan under transfer case.
- Remove drain and fill plugs and drain lubricant completely.
- Install drain plug. Tighten plug to 20-34 N.m (15-25 ft. lbs.).
- Remove drain pan.
- Fill transfer case to bottom edge of fill plug opening with the required fluid. Refer to DESCRIPTION .
- Install and tighten fill plug to 20-34 N.m (15-25 ft. lbs.).
1 - DAMPER 2 - REAR HOUSING - Install the transfer case damper (1) onto the rear case (2). See Figure.
1 - BOLTS 2 - DAMPER 3 - REAR HOUSING - Install the bolts (1) to hold the damper (2) to the rear case (3). Tighten the bolts to 27 N.m (20 ft. lbs.). See Figure.
- Lower vehicle.