LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2006 >> Liberty Renegade, 4WD, Part Time, Standard >> Repair and Diagnosis >> Suspension >> Wheel Alignment >> Suspension System >> Front >> Upper Control Arm >> Installation >> Left Side

Left Side

Fig 1: Upper Control Arm
GC0025567Courtesy of DAIMLERCHRYSLER CORP.
1 - FRONT PIVOT BOLT
2 - REAR PIVOT BOLT
3 - RATCHET TOOL
4 - STEERING KNUCKLE
  1. Install the upper control arm to the vehicle.
  2. Install the upper control arm front bolt (1). See Fig 1. Tighten the bolt to 122 N.m (90 ft.lbs.).
  3. Install the upper control arm rear bolt (2). See Fig 1. Tighten the bolt to 122 N.m (90 ft.lbs.).
  4. Reconnect the battery temperature sensor to the battery tray.
  5. Install the battery tray (Refer to ELECTRICAL/BATTERY SYSTEM/TRAY - INSTALLATION) .
  6. Install the battery (Refer to ELECTRICAL/BATTERY SYSTEM/BATTERY - INSTALLATION) .
  7. Reclip and mount the power center.
    Fig 2: Upper Control Arm
    GC0025567Courtesy of DAIMLERCHRYSLER CORP.
    1 - FRONT PIVOT BOLT
    2 - REAR PIVOT BOLT
    3 - RATCHET TOOL
    4 - STEERING KNUCKLE
  8. Install the upper ball joint nut. See Fig 1. Tighten the nut to 81 N.m (60 ft.lbs.).
  9. Install the left side tire and wheel assembly. (Refer to TIRES/WHEELS/WHEELS - STANDARD PROCEDURE) .
  10. Lower the vehicle.
  11. Perform a wheel alignment (Refer to SUSPENSION/WHEEL ALIGNMENT - STANDARD PROCEDURE) .
scientia non olet · About LEMON Manuals