LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2006 >> Commander Base, 3.7 K, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 43 (Vehicle Theft Security System (Service Information)) >> Intrusion Sensor >> Installation >> Receiver

Intrusion Sensor: Installation: Receiver

WARNING: This page is about a different car, the 2006 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Removing/Installing Intrusion Sensor Receiver
GC0040906Courtesy of DAIMLERCHRYSLER CORP.
  1. Position the intrusion sensor receiver (1) to the mounting bracket (4) on the right front corner of the overhead console housing (3).
  2. Press the receiver down until the three latch features (2) of the bracket are fully engaged.
  3. Reconnect the take out of the overhead wire harness to the connector receptacle (5) on the rearward end of the receiver housing.
  4. Reinstall the overhead console onto the headliner. (Refer to OVERHEAD CONSOLE - INSTALLATION) .
  5. Reconnect the battery negative cable.
scientia non olet · About LEMON Manuals