LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2006 >> Commander Base, 3.7 K, AWD >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Vehicle Theft Security System (Service Information) >> Intrusion Sensor >> Removal >> Receiver

Intrusion Sensor: Removal: Receiver

Fig 1: Remove/Install Receiver
GC0045726Courtesy of DAIMLERCHRYSLER CORP.
  1. Disconnect and isolate the battery negative cable.
  2. Remove the overhead console from the headliner. (Refer to ELECTRICAL/OVERHEAD CONSOLE - REMOVAL) .
  3. Locate the intrusion sensor receiver (3) in the mounting bracket (4) on the left rear corner of the overhead console housing (5).
  4. Disconnect the take out of the overhead wire harness from the connector receptacle (2) on the forward end of the receiver housing.
  5. Release the three latch features (1) of the mounting bracket and disengage the receiver from the bracket.
scientia non olet · About LEMON Manuals