LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2004 >> Liberty Limited, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 76 (Wiper System & Washer System) >> Front Wiper Module >> Assembly

Front Wiper Module: Assembly

WARNING: This page is about a different car, the 2004 Jeep Wrangler. However, it is still accessible from the selected car via links, so may be relevant.

The front wiper motor and its rubber boot are available for service replacement. Following are the procedures for reassembling these components onto the front wiper module unit.

  1. Position the wiper motor onto the front wiper module bracket.
  2. Install and tighten the three screws that secure the wiper motor to the front wiper module bracket. Tighten the screws to 8 N.m (70 in. lbs.).
  3. Position the wiper motor crank arm onto the front wiper motor output shaft.
  4. Install and tighten the nut that secures the wiper motor crank arm to the front wiper motor output shaft. Tighten the nut to 12 N.m (101 in. lbs.).
  5. Engage the wiper motor pigtail wire connector retainer in the locating hole on the front wiper module bracket.
  6. Reinstall the front wiper module into the cowl plenum. See INSTALLATION  .
scientia non olet · About LEMON Manuals