Work Procedure

Always perform the distance sensor configuration after replacing the distance sensor.
Always perform the radar alignment after removing and installing or replacing the distance sensor.
CAUTION:
The system does not operate normally unless the distance sensor configuration and the radar alignment are performed. Always perform them.
Perform the FEB system action test to check that the FEB system operates normally.

DISTANCE SENSOR CONFIGURATION
1. Perform the distance sensor configuration with CONSULT. Refer to Work Procedure .
>>

GO TO 2.
PERFORM RADAR ALIGNMENT
1. Perform the radar alignment. Refer to Work Procedure .
>>

GO TO 3.
FEB SYSTEM ACTION TEST
1. 1. Perform the following system action test.
    - LDW: Refer to Work Procedure .
    - LDP: Refer to Work Procedure .
    - BSW: Refer to Work Procedure .
    - Blind Spot Intervention: Refer to Work Procedure .
    - TSR: Refer to Work Procedure .
    - RCTA: Refer to Work Procedure .
    - DAA: Refer to Work Procedure .
  2. Check that the each system operates normally.
>>

INSPECTION END