LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2014 >> Q70 3.7, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 47 (Security Control System (Hybrid)) >> Basic Inspection >> Additional Service When Replacing Control Unit >> HPCM >> HPCM: Work Procedure

HPCM: Work Procedure

WARNING: This page is about a different variant/trim than selected.
  1. PERFORM HPCM RECOMMUNICATING FUNCTION 
    1. Install HPCM.
    2. Contact backside of registered Intelligent key* to push-button ignition switch while brake pedal is depressed, then turn ignition switch ON.

      *: To perform this step, use the key that is used before performing HPCM replacement.

    3. Maintain ignition switch in the ON position for at least 5 seconds.
    4. Turn ignition switch OFF.
    5. Check that the vehicle can be set to READY.

    : GO TO  2.

  2. PERFORM ADDITIONAL SERVICE WHEN REPLACING HPCM 

    Perform the following procedure, "WORK PROCEDURE ".

    : END

scientia non olet · About LEMON Manuals