Section 25 (Charging System (1GR-FE)): Generator: Removal

WARNING: This page is about a different car, the 2008 Toyota Tundra. However, it is still accessible from the selected car via links, so may be relevant.

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTE:
- Some systems need to be initialized after the cable is reconnected (see INITIALIZATION ).
- After the ignition switch is turned OFF, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch OFF, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.
REMOVE BATTERY
REMOVE V-BANK COVER (See REMOVAL )
REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY (See REMOVAL )
REMOVE FAN AND GENERATOR V BELT (See REMOVAL )
REMOVE GENERATOR ASSEMBLY
1. Remove the nut and disconnect the wire harness clamp bracket.
  
  Fig 1: Identifying Wire Harness Clamp Bracket Nut
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Disconnect the generator connector.
3. Remove the terminal cap.
4. Remove the nut and disconnect the generator wire.
5. Remove the wire harness clamp.
6. Remove the bolt and disconnect the wire harness clamp bracket.
  
  Fig 2: Identifying Wire Harness Clamp Bracket Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
7. Remove the 2 bolts and generator.
  
  Fig 3: Identifying Generator Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002