Electronic Stability Control (ESC) System

• Components And Components Location
  • Components
• Description And Operation
  • Description Of ESC
    • Notes
    • Description of ESC Control
    • Input and Output Diagram
  • ESP Operation Mode
    • ESP Hydraulic System Diagram
    • ABS Warning Lamp module
    • EBD/Parking Brake Warning Lamp Module
    • ESP Function/Warning Lamp (ESP System)
    • ESP OFF Lamp (ESP System)
    • ESP ON/OFF Switch (ESP System)
• Schematic Diagrams
  • Schematic Diagram
  • Terminal Function
• Repair Procedures
  • ESC Bleeding Of Brake System
• Troubleshooting
  • Failure Diagnosis
    • Notes
    • Memory of Fail Code
    • Failure Checkup
    • Countermeasures in Fail
    • Warning Lamp ON
    • Standard Flow of Diagnostic Troubleshooting
    • Notes with Regard to Diagnosis
    • ABS Check Sheet
    • Problem Symptoms Table
  • ABS Does Not Operate
    • Detecting condition
    • Inspection procedures
      • DTC Inspection
    • Check the power source circuit
    • Check the ground circuit
    • Check the wheel speed sensor circuit
    • Check the hydraulic circuit for leakage
  • ABS Does Not Operate (Intermittently)
    • Detecting condition
    • Inspection procedures
      • DTC Inspection
    • Check the wheel speed sensor circuit
    • Check the stop lamp switch circuit
    • Check the hydraulic circuit for leakage
  • Communication with GDS is not possible (Communication with any system is not possible)
    • Detecting condition
    • Inspection procedures
      • Check The Power Supply Circuit For The Diagnosis
      • Check for Continuity in the CAN Line
    • Check the ground circuit for the diagnosis
    • Check the power source of ESC control module
    • Check for poor ground
  • When Ignition Key is Turned ON (engine OFF), The ABS Warning Lamp Does Not Light Up
    • Detecting condition
    • Inspection Procedures
      • Problem verification
    • Check the power source for the ABS warning lamp
    • Check the CAN circuit resistance for ABS warning lamp
    • Check the CAN circuit wiring for ABS warning lamp
  • Even After The Engine is Started, The ABS Warning Lamp Remains ON
    • Detecting condition
    • Inspection procedures
      • Check DTC Output
    • Check the CAN circuit resistance for ABS warning lamp
    • Check the CAN circuit wiring for ABS warning lamp
• ESC Control Module
  • Components And Components Location
    • Components
  • Repair Procedures
    • Removal
    • Installation
    • Diagnosis procedure by using diagnostic device
      • Notes
      • [Variant Coding]
      • [Auto Detected Sensor Calibration]
      • [Longitudinal G Sensor Calibration]
• ESC OFF Switch
  • Description And Operation
    • Description
  • Repair Procedures
    • Inspection
• DBC Switch
  • Description And Operation
    • Description
  • Repair Procedures
    • Inspection
• Emergency Signal System
  • Description And Operation
    • Description
      • Introduction of quick brake warning system (ESS)
      • System configuration
      • ESS Circuit diagram
• Front Wheel Speed Sensor
  • Components And Components Location
    • Components
  • Repair Procedures
    • Removal And Installation
    • Inspection
• Rear Wheel Speed Sensor
  • Components And Components Location
    • Components
      • [2WD]
      • [4WD]
  • Repair Procedures
    • Removal And Installation
    • Replacement
    • Inspection