Repair procedures: Installation

WARNING: This page is about a different car, the 2016 Hyundai Elantra and 2015 Hyundai Elantra. However, it is still accessible from the selected car via links, so may be relevant.

Install in the reverse order of removal.
NOTE:
- Use a SST (09480-A3800) or 0.1969in. (5mm) bolt fix the inhibitor manual control lever in the N jig hole (A) when you assemble the inhibitor (B).
  
  Fig 1: Installing Inhibitor Manual Control Lever In N Jig Hole
  Courtesy of HYUNDAI MOTOR AMERICA
- Adjust the shift cable after you install the inhibitor switch.
  (Refer to "ADJUSTMENT ")