Engine Control System / Engine Mechanical - Testing & Troubleshooting (Hybrid)
- Symptom Troubleshooting Index for Viewer
- After warming up, idle speed is above specifications without load (MIL works OK, no DTCs set)
- After warming up, idle speed is below specifications without load (MIL works OK, no DTCs set)
- Cold fast idle too high (MIL works OK, no DTCs set)
- Cold fast idle too low (MIL works OK, no DTCs set)
- Difficult to refuel (MIL works OK, NO DTCs set)
- Engine is hard to start (MIL works OK, no DTCs set)
- Engine stalls (MIL works OK, no DTCs set)
- Engine starts but stalls immediately (MIL works OK, no DTCs set, immobilizer indicator stays on or flashes)
- Engine will not start (MIL works OK, no DTCs set, generator motor works OK)
- Engine will not start, and HDS does not communicate with the PCM (MIL comes on and stays on, no DTCs set)
- HDS does not communicate with the PCM or the vehicle
- Idle speed fluctuates (MIL works OK, no DTCs set)
- Low power (MIL works OK, no DTCs set)
- MIL comes on and stays on, or never comes on at all, no DTCs set
- Description & Operation
- Removal, Installation & Inspection
- General Information
- Rewrite
- Inspection
- Replacement
- Servicing
- How to Information
- Test
- Connector View
- Check
- Troubleshooting
- Adjustment
- Component Location Index
- Learning, Reset & Clear