Transmission Fluid Temperature Sensor Test: Test
- 1. HDS DLC - Connect
- 2. SCS - Short
1. Turn the vehicle to the OFF (LOCK) mode
2. Jump the SCS line with the HDS, and wait more than 1 minute.
- 3. Transmission Fluid Temperature Sensor - Internal Resistance Check
- 1. Disconnect the PCM connector C (51P) .
- 2. Measure the transmission fluid temperature sensor resistance between the following test points 1 and 2.
Test point 1 PCM connector C (51P) No. 37 Test point 2 Body ground Standard: 50 Ω-25 kΩ
- If the resistance is within the standard, then the test is complete.
- If the resistance is out of the standard, check for open or short in the solenoid wire harnesses A. If the wires are OK, replace the transmission fluid temperature sensor - Refer to: Solenoid Wire Harness B Removal and InstallationSolenoid Wire Harness A Removal and Installation .
- 4. All Removed Parts - Install the parts in the reverse order of removal.