Center Console Trim Disassembly/Reassembly

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2014 Honda Ridgeline, 2013 Honda Ridgeline, 2012 Honda Ridgeline, 2011 Honda Ridgeline, and 2010 Honda Ridgeline. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Take care not to scratch the armrest.

Remove the center console trim (see step 2 on CENTER CONSOLE REMOVAL/INSTALLATION ).
Disassemble the center console trim.
1. -1 Disconnect the accessory socket connector (A) and the light bulb socket (B), and detach the harness clips (C).
2. -2 Remove the screws (D), using a TORX T20 bit, then remove the console vent (E) and the console duct (F).
3. -3 Remove the screws (G), using a TORX T20 bit, then remove the hooks (H).
Fig 1: Identifying Accessory Socket Connector, Light Bulb Socket, Harness Clips Console Vent And Console Duct
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Reassemble the console in the reverse order of disassemble, and make sure the accessory socket connector and the light bulb socket are plugged in properly.