Center Console Removal/Installation

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2014 Honda Ridgeline, 2013 Honda Ridgeline, 2012 Honda Ridgeline, 2011 Honda Ridgeline, and 2010 Honda Ridgeline. However, it is still accessible from the selected car via links, so may be relevant.

Special Tools Required

KTC trim tool set SOJATP2014 *

* Available through the Honda Tool and Equipment Program; call 888-424-6857

SRS components are located in this area. Review the SRS component locations (see COMPONENT LOCATION INDEX ) and the precautions and procedures (see PRECAUTIONS AND PROCEDURES ) before doing repairs or service.

NOTE:

Put on gloves to protect your hands.
Take care not to scratch the front seat, dashboard, and related parts.
Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.

Remove the dashboard center lower cover (see DASHBOARD CENTER LOWER COVER REMOVAL/INSTALLATION ).
Detach the clips, then remove the console trim (A). Disconnect the subharness connector (B), the console box light 2 connector (C), and if equipped, the AC power outlet connector (D), and detach the connector clip.

Fig 1: Identifying Console Trim, Subharness Connector, Console Box Light 2 Connector And AC Power Outlet Connector
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Pull the center floor tray (A) up by hand to detach the clips, then remove it.

Fig 2: Pulling Center Floor Tray Up
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Remove the bolts (A) and screws (B), then remove the center console (C).

Fig 3: Center Console With Bolts And Screws With Torque Specifications
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the console in the reverse order of removal, and note these items.

If the clips are damaged or stress-whitened, replace them with new ones.
Make sure the connectors are plugged in properly.