Steering Angle Sensor Replacement

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2014 Honda Ridgeline, 2013 Honda Ridgeline, 2012 Honda Ridgeline, 2011 Honda Ridgeline, and 2010 Honda Ridgeline. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Do not damage or drop the combination switch as the steering angle sensor is sensitive to shock and vibration.

Make sure the ignition switch is in LOCK (0).
With the wheels in the straight-ahead position and the steering wheel centered, remove the steering wheel (see STEERING WHEEL REMOVAL ), and steering column cover (see step 5 on REMOVAL ).
Remove the cable reel (see CABLE REEL REPLACEMENT ) and the combination switch assembly (see step 7 on REMOVAL ).
Remove the wiper/turn switch (A).

Fig 1: Identifying Wiper/Turn Switch And Combination Switch Body Assembly
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Replace the combination switch body assembly (B).
Install the combination switch in the reverse order of removal.
NOTE:
- Do not remove the steering angle sensor from the combination switch body.
- When installing the cable reel, set the turn signal canceling sleeve position (see CABLE REEL REPLACEMENT ).
Do the steering angle sensor center point writing (see STEERING ANGLE SENSOR CENTER POINT WRITING ).