Steering Angle Sensor Center Point Writing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2014 Honda Ridgeline, 2013 Honda Ridgeline, 2012 Honda Ridgeline, 2011 Honda Ridgeline, and 2010 Honda Ridgeline. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Before doing the steering angle sensor center point writing, place the vehicle on a flat level surface, and turn the steering wheel to the straight ahead position while moving the vehicle.

With the ignition switch at LOCK (0), connect the HDS to the data link connector (DLC) (A) under the driver's side of the dashboard.

Fig 1: Identifying Data Link Connector (DLC)
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Turn the ignition switch to ON (II).
Make sure the HDS communicates with the vehicle and the VSA modulator-control unit. If it doesn't, troubleshoot the DLC circuit (see DLC CIRCUIT TROUBLESHOOTING ).
Do the steering angle sensor center point writing in the VSA ADJUSTMENT menu with the HDS.
NOTE: See the HDS Help menu for specific instructions.
Turn the ignition switch to LOCK (0).