DTC 1302: GPS Receiver Error 1
WARNING: This page is about a different car, the 2011 Honda Fit, 2010 Honda Fit, and 2009 Honda Fit. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- Check the vehicle battery condition first.
- Before you troubleshoot, make sure to follow GENERAL TROUBLESHOOTING INFORMATION .
- Make sure the vehicle is parked outside, away from buildings.
- Aftermarket metallic window tint or electronic devices located near the audio-navigation unit or GPS antenna can potentially interfere with the operation of the navigation system.
- Clear the hard error code (see HOW TO CLEAR ERROR HISTORY ).
- Turn the ignition switch to LOCK (0), and then back to ON (II).
- Check for the hard error code (see How to Check Error History
).
Is DTC 1302 indicated?
YES - Go to step 4.
NO - Intermittent failure, the system is OK at this time. If the unit repeatedly comes back with the DTC, replace the audio-navigation unit (see AUDIO-NAVIGATION UNIT REMOVAL/INSTALLATION ).
- Turn the ignition switch to LOCK (0).
- Check for poor connections or loose terminals at the audio-navigation unit connector H (2P).
- Clear the hard error code.
- Turn the ignition switch to LOCK (0), and then back to ON (II).
- Check for the hard error code.
Is DTC 1302 indicated?
YES - Replace the GPS antenna (see GPS ANTENNA REMOVAL/INSTALLATION ), then retest. If the DTC does not clear, replace the audio-navigation unit (see AUDIO-NAVIGATION UNIT REMOVAL/INSTALLATION ).
NO - Intermittent failure, the system is OK at this time. If the unit repeatedly comes back with the DTC, replace the audio-navigation unit (see AUDIO-NAVIGATION UNIT REMOVAL/INSTALLATION ).