DTC 1302: GPS Receiver Error 1
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2017 Honda Odyssey, 2016 Honda Odyssey, 2015 Honda Odyssey, 2014 Honda Odyssey, and 2013 Honda Odyssey. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- Check the vehicle battery condition first (see BATTERY TEST ).
- This navigation DTC sets when there is an internal GPS receiver problem.
- Check any official Honda service website for more service information about the navigation system.
- Before you troubleshoot, make sure to follow the General Troubleshooting Information (see GENERAL TROUBLESHOOTING INFORMATION ).
- Make sure the vehicle is parked outside, away from buildings.
- Aftermarket electronic devices located near the audio-navigation unit or GPS antenna can potentially interfere with the operation of the navigation system.
- Clear the hard error code (see HOW TO CLEAR ERROR HISTORY ).
- Turn the ignition switch to LOCK (0), then back to ON (II), and wait at least 1 minute.
- Check for the hard error code (see HOW TO CHECK ERROR HISTORY (NAVIGATION DTCS)
).
Is DTC 1302 indicated?
YES -Go to step 4.
NO -Intermittent failure, the system is OK at this time.
- Turn the ignition switch to LOCK (0).
- Check for poor connections or loose terminals at audio-navigation unit connector J (2P).
Is the connection OK?
YES -Replace the audio-navigation unit (see AUDIO-NAVIGATION UNIT REMOVAL/INSTALLATION ).
NO -Repair poor connections or loose terminals, and recheck. If the vehicle repeatedly comes back with the navigation DTC, replace the GPS antenna (see FRONT HFL-NAVIGATION-ANC MICROPHONE REMOVAL/INSTALLATION ).