LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2006 >> Ridgeline RTS >> Repair and Diagnosis >> External Pages >> Different car >> Section 69 (Tire Pressure Monitoring System) >> Initiator Replacement >> Front

Initiator Replacement: Front

WARNING: This page is about a different car, the 2008 Honda Pilot, 2007 Honda Pilot, and 2006 Honda Pilot. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Make sure the initiator mounting bracket is not bent or twisted as this may affect its communication with the TPMS control unit and the tire pressure sensor.
  1. Turn the ignition switch OFF.
  2. Raise the front of the vehicle, and support it with safety stands in the proper locations (see LIFT AND SUPPORT POINTS ).
  3. Remove the front wheel.
  4. Remove the front inner fender (see FRONT INNER FENDER REPLACEMENT ).
  5. Disconnect the initiator connector (A).
    Fig 1: Initiator Connector, Initiator And Bracket With Torque Specifications
    G05594705Courtesy of AMERICAN HONDA MOTOR CO., INC.
  6. Remove the initiator (B) with the bracket (C) from the inner side of the wheelwell.
  7. Remove the initiator from the bracket.
  8. Install the initiator in the reverse order of removal.
scientia non olet · About LEMON Manuals