Installation Procedure
- Inspect and clean the sealing surfaces of the EBCM and the BPMV with denatured alcohol and allow to dry.
- Inspect the EBCM to BPMV gasket for damage and replace, if necessary.
- NOTE:
Brake pipes not shown for graphic clarity. It is not necessary to remove the brake pipes from the BPMV.
Electronic Brake Control Module (1) - Install
- CAUTION:
Refer to Torque-to-Yield Fastener Caution .
NOTE:Brake pipes not shown for graphic clarity. It is not necessary to remove the brake pipes from the BPMV.
Electronic Brake Control Module Bolt (2) - Install NEW and tighten in sequence [4x] - Fastener Specifications
- Connect the electrical connector. (1)
- Front Wheelhouse Liner - Install - Front Wheelhouse Liner Replacement
- Program the electronic brake control module. Control Module References
- Calibrate the BPMV pressure sensor. Brake Pressure Modulator Valve Pressure Sensor Calibration