Removal Procedure
WARNING: This page is about a different variant/trim than selected.
- Raise and suitably support the vehicle. Lifting and Jacking the Vehicle
- Remove the power transfer unit heat shield, if equipped. Power Transfer Unit Heat Shield Replacement (M3D transmission with LSY engine)
- NOTE:
When performing the following procedure, use only hand tools to remove and install the drain and fill plugs.
NOTE:Ensure that an approved drain pan is used when draining the transfer case.
Remove and DISCARD the oil drain plug (2) and seal.
- Remove and DISCARD the fill plug (1) and seal.
- Allow the transfer case to drain completely.