Test Description
WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
The number below refers to the step number on the diagnostic table.
- 3: Tests the pump motor circuits of the BPMV for a short to the housing of the BPMV. The wiring from the BPMV to the EBCM should not be repaired.
DTC C0110
| Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
| Schematic Reference: ABS Schematics Connector End View Reference: ABS Connector End Views |
||||
| 1 | Did you perform the ABS Diagnostic System Check? | - | Go to Step 2 | Go to Diagnostic System Check - ABS |
| 2 |
|
- | Go to Step 8 | Go to Step 3 |
| 3 |
|
5 Ω | Go to Step 4 | Go to Step 5 |
| 4 | Inspect for poor connections at the pump motor harness pigtail connector of the BPMV. Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
in Wiring Systems. Did you find and correct the condition? |
- | Go to Step 8 | Go to Step 6 |
| 5 | Inspect for poor connections at the harness connector of the EBCM. Refer Testing for Intermittent Conditions and Poor Connections
to Connector Repairs
and in Wiring Systems. Did you find and correct the condition? |
- | Go to Step 8 | Go to Step 7 |
| 6 | Replace the BPMV. Refer to Brake Pressure Modulator Valve (BPMV) Replacement . Did you complete the repair? |
- | Go to Step 8 | - |
| 7 | Replace the EBCM. Refer to Electronic Brake Control Module Replacement . Did you complete the repair? |
- | Go to Step 8 | - |
| 8 |
|
- | Go to Step 2 | System OK |