LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2007 >> Durango 3.7 K >> Repair and Diagnosis >> Electrical >> Gauges >> Overhead Console (Service Information) >> Overhead Console - Service Information >> HOMELINK Transceiver >> Standard Procedure >> Reprogramming Transmitter Codes >> Reprogramming Basic HomeLink® Transceiver Codes

Reprogramming Basic HomeLink® Transceiver Codes

WARNING: Vehicle exhaust contains carbon monoxide, a dangerous gas. Do not run the vehicle's exhaust while training the HomeLink® transceiver. Exhaust gas can cause serious injury or death.
WARNING: Your motorized door or gate may open and close while you are training the HomeLink® Transceiver if the vehicle is in range of the motorized device. Do not train the HomeLink® transceiver if people or pets are in the path of the door or gate. A moving door or gate can cause serious injury or death to people and pets or damage to objects.
NOTE: If programing the HomeLink® transceiver is unsuccessful using the following procedure, refer to the Owner's Manual for the current customer assistance phone number.

To program a device to the HomeLink® transceiver using a button previously trained, follow these steps:

  1. Press and hold the desired HomeLink® transceiver button. DO NOT  release the button. The EVIC will display "CHANNEL X TRANSMIT" for 20 seconds and then change to "CHANNEL X TRAINING". Without releasing the HomeLink® transceiver button, proceed to step 2.
  2. Position the end of your hand-held transmitter 3-8 cm (1-3 inches) away from the HomeLink® transceiver button while keeping the EVIC display in view.
  3. Simultaneously press and hold both the HomeLink® transceiver button that you want to train and the hand-held transmitter buttons. Do not release the buttons until step 4 has been completed.  The EVIC will display "CHANNEL X TRAINING", once the HomeLink® transceiver is programmed the EVIC will display "CHANNEL X TRAINED". X refers to the desired channel being trained (1, 2 or 3).
    NOTE: Some gate operators and garage door openers may require you to replace this Reprogramming Step 3 with procedures noted in the "Canadian Programming/Gate Programming " section.
  4. Once "CHANNEL X TRAINED" is displayed on the EVIC, release both buttons. Programming is now complete. When the HomeLink® transceiver button is subsequently pressed, "CHANNEL X TRANSMIT" is displayed on the EVIC and your device should be activated, (garage door should open).
    NOTE: If the EVIC display shows "CHANNEL X TRANSMIT" (where X is channel 1, 2 or 3) but your device does not activate, the device may be equipped with a "rolling code" system. Continue with the following steps 5 through 7 to complete the programming of a rolling code equipped device (most commonly a garage door opener manufactured after 1995). The assistance of a second person may make the following programming steps quicker and easier.
  5. At the garage door opener receiver (motor-head unit) in the garage, locate the "learn" or "smart" button. This can usually be found where the hanging antenna wire is attached to the motor-head unit.
  6. Firmly press and release the "learn" or "smart" button. (The name and color of the button may vary by manufacturer.)
    NOTE: There are 30 seconds in which to initiate step 7.
  7. Return to the vehicle and firmly press, hold for two seconds and release  the reprogrammed HomeLink® transceiver button. Repeat the "press/hold/release"  sequence a second time, and, depending on the brand of the garage door opener (or other rolling code equipped device), repeat this sequence a third time to complete the reprogramming.

    The HomeLink® transceiver should now activate your rolling code equipped device.

scientia non olet · About LEMON Manuals