LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2007 >> Durango 3.7 K >> Repair and Diagnosis >> Electrical >> Gauges >> Overhead Console (Service Information) >> Overhead Console - Service Information >> HOMELINK Transceiver >> Standard Procedure >> Reprogramming Transmitter Codes >> Canadian Programming/Gate Programming

Canadian Programming/Gate Programming

Canadian radio-frequency laws require transmitter signals to "time-out" (or quit) after several seconds of transmission which may not be long enough for the HomeLink® transceiver to pick up the signal during programming. Similar to this Canadian law, some U.S. gate operators are designed to "time-out" in the same manner.

If you live in Canada or you are having difficulties programming a gate operator by using the "Programming" procedures (regardless of where you live), replace "Programming Common HomeLink® Transceiver Codes" step 3  with the following:

NOTE: When programming a garage door opener or gate operator, it is advised to unplug the device or move the vehicle out of range during the "cycling" process to prevent possible overheating.
  1. 3  . Continue to press and hold the HomeLink® transceiver button while you press and release every two seconds  ("cycle") your hand-held transmitter until the frequency signal has successfully been accepted. The EVIC will display "CHANNEL X TRAINING" and then "CHANNEL X TRAINED". Proceed with "Programming" step  4 to complete.
scientia non olet · About LEMON Manuals