Sensor-Accelerator Pedal Position: Removal
WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Courtesy of DAIMLERCHRYSLER CORP.
| 1 - HARNESS CONNECTOR |
| 2 - FASTENERS |
| 3 - ACCELERATOR PEDAL ASSEMBLY |
- Disconnect the negative battery cable.
- Remove the drivers side lower dash board close out panel.
- Disconnect the APP sensor electrical connector (1). See Fig 1.
- Remove the accelerator pedal assembly fasteners (2) and the accelerator pedal assembly (3). See Fig 1.