Sensor-Accelerator Pedal Position: Installation
WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Courtesy of DAIMLERCHRYSLER CORP.
| 1 - HARNESS CONNECTOR |
| 2 - FASTENERS |
| 3 - ACCELERATOR PEDAL ASSEMBLY |
- Connect the accelerator pedal position sensor wiring harness connector (1) to the sensor. See Fig 1.
- Position the accelerator pedal assembly (3) and install the fasteners (2). See Fig 1.
- Install the drivers lower dash board close out panel.
- Connect the negative battery cable.