LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2005 >> 300 Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 272 (Battery System) >> Battery Tray >> Removal >> Left Side

Left Side

WARNING: This page is about a different car, the 2005 Dodge Pickup and 2005 Dodge Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the battery (3) from the battery tray (Refer to ELECTRICAL/BATTERY SYSTEM/BATTERY - REMOVAL) .
  2. Remove the Integrated Power Module (IPM) (5) (Refer to ELECTRICAL/POWER DISTRIBUTION/INTELLIGENT POWER MODULE - REMOVAL) .
  3. Disconnect the wire harness retainers from the battery tray assembly.
  4. Disconnect the purge solenoid (6) from its mounting bracket.
  5. Remove the anti-lock brake controller (if equipped) retaining bolts and support the brake controller with mechanics wire. It is not necessary to completely remove the anti-lock brake control unit.
  6. Remove the left front wheelhouse splash shield (Refer to BODY/EXTERIOR/LF WHEELHOUSE SPLASH SHIELD - REMOVAL) .
    Fig 1: Removing Battery Tray (Left Side) 1 Of 2
    GC0008566Courtesy of DAIMLERCHRYSLER CORP.
  7. Mark the location of the cruise servo (3) (if equipped) and remove the retaining screws. Position the servo out of the way.
  8. Remove the battery temperature sensor from the battery tray (Refer to ELECTRICAL/CHARGING/BATTERY TEMPERATURE SENSOR - REMOVAL) .
  9. Disconnect the left front fender ground wire.
  10. Remove the remaining battery tray retaining bolts (2).
  11. Remove the battery tray from the vehicle.
    Fig 2: Removing Battery Tray (Left Side) 2 Of 2
    GC0008564Courtesy of DAIMLERCHRYSLER CORP.
scientia non olet · About LEMON Manuals