LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2005 >> 300 Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 142 (Fuel Injection - Gas Engine) >> Throttle Control Cable >> Installation >> 5.7L V-8

5.7L V-8

WARNING: This page is about a different car, the 2004 Dodge Pickup and 2004 Dodge Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Attach cable to Accelerator Pedal Position Sensor (APPS). Refer to INSTALLATION .
  2. Push cable housing into rubber grommet and through opening in dash panel.
  3. From inside vehicle, install clip holding cable to dash panel (Figure).
  4. From inside vehicle, slide throttle cable core wire into opening in top of pedal arm.
  5. Push cable retainer (clip) into pedal arm opening until it snaps in place.
  6. Before starting engine, operate accelerator pedal to check for any binding.
  7. If necessary, use DRB III® Scan Tool to erase any APPS Diagnostic Trouble Codes (DTC's) from PCM.
scientia non olet · About LEMON Manuals