LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2005 >> 300 Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 142 (Fuel Injection - Gas Engine) >> Accelerator Pedal Position Sensor >> Installation

Accelerator Pedal Position Sensor: Installation

WARNING: This page is about a different car, the 2004 Dodge Pickup and 2004 Dodge Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install Accelerator Pedal Position Sensor (APPS) cable to accelerator pedal. Refer to Accelerator Pedal INSTALLATION .
  2. Connect electrical connector to APPS.
  3. If necessary, connect cable to APPS lever ball socket (snaps on).
  4. Snap APPS cable cover closed.
  5. Position APPS assembly to bottom of battery tray and install 3 bolts. Tight bolts to 30 in. lbs. (3 N.m).
  6. Install wheelhouse liner.
  7. The 5.7L V-8 engine is equipped with a fully electronic accelerator pedal position sensor. If equipped with a 5.7L, also perform the following 3 steps: 
    1. Connect negative battery cable to battery.
    2. Turn ignition switch ON, but do not crank engine.
    3. Leave ignition switch ON for a minimum of 10 seconds. This will allow PCM to learn electrical parameters.
    4. The DRB III® Scan Tool may also be used to learn electrical parameters. Go to the Miscellaneous menu , and then select ETC Learn.
  8. If the previous step is not performed, a Diagnostic Trouble Code (DTC) will be set.
  9. If necessary, use DRB III® Scan Tool to erase any Diagnostic Trouble Codes (DTC's) from PCM.
scientia non olet · About LEMON Manuals