LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2005 >> 300 Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 142 (Fuel Injection - Gas Engine) >> Accelerator Pedal >> Installation

Accelerator Pedal: Installation

WARNING: This page is about a different car, the 2004 Dodge Pickup and 2004 Dodge Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Place accelerator pedal assembly over 2 studs.
  2. Install and tighten 2 mounting nuts to 105 in. lbs. (12 N.m). .
  3. Slide throttle cable into opening slot in top of pedal arm.
  4. Push plastic cable retainer (clip) into accelerator pedal arm opening until it snaps into place.
  5. Before starting engine, operate accelerator pedal to check for any binding.
scientia non olet · About LEMON Manuals