Rear Power Module: Installation
WARNING: This page is about a different car, the 2001 Dodge Grand Caravan and 2001 Chrysler Town & Country. However, it is still accessible from the selected car via links, so may be relevant.
- Position the blower power module into the rear heater-A/C unit housing. Install the two screws that secure the blower power module to the rear heater-A/C unit housing. Tighten the screws to 17 INCH lbs. (2 N.m).
- Reconnect the blower motor pigtail wire to the blower power module connector receptacle. Reconnect the rear HVAC wire harness connector for the blower power module to the module connector receptacle.
- Reinstall the right quarter trim panel and right D-pillar trim panel onto the quarter inner panel:
- Position D-pillar trim on vehicle.
- Pass second row seat belt, if equipped, through slot in trim panel on short wheel base vehicle.
- Connect speaker wire connector to speaker, if equipped.
- Align locating pins on backside of trim panel to mating holes in D-pillar.
- Engage hidden clips attaching trim to D-pillar.
- Install screws attaching trim panel to attaching bracket on short wheel base vehicle.
- Install quarter trim bolster on short wheel base vehicle.
- Install bolt to attach second row seat belt, if equipped, anchor to quarter on short wheel base vehicle.
- Tighten all seat belt bolts to 29 ft. lbs. (39 N.m).
- Install second row seat belt turning loop on long wheel base vehicle.
- Install liftgate sill plate.
- Install rear header trim cover.
- Reconnect the battery negative cable.