Bleeding Brake System: Notes
CAUTION:
During bleeding procedure, ensure master cylinder fluid level remains close to FULL mark. Check master cylinder fluid level periodically while bleeding system. Add brake fluid as required. Use DOT 3 brake fluid from a sealed container. If DOT 3 brake fluid is not available, DOT 4 or DOT 4+ may be used.
NOTE:
Teves Mark 20 Anti-Lock Brake System (ABS) must be bled as 2 independent braking systems. Always bleed base brake system first using manual bleeding or pressure bleeding procedure. See MANUAL BLEEDING or PRESSURE BLEEDING plus ABS BLEEDING
. Bleed system using either conventional bleeding method, then using ABS bleeding method. After completing ABS bleeding method, repeat conventional bleeding method.
Observe following precautions during brake bleeding procedure.
- DO NOT allow master cylinder to run out of fluid when bleeding brakes. Check fluid level frequently and add fluid as necessary.
- DO NOT pump brake pedal during bleeding procedure unless directed to do so.
- Bleed only one brake system component at a time. Use a bleed hose on each wheel cylinder and caliper bleed screw.
- Be sure to tighten each bleed screw when bleeding is complete.
- If master cylinder has been overhauled or a new cylinder is to be installed, bench bleed master cylinder before installation.