LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring Limited >> Repair and Diagnosis (Single Page) >> Body & Frame >> Body, Cab Control Systems >> Body Control Modules - Except Coupe >> System Tests >> Instrument Cluster Systems >> Malfunction Indicator Light Not Operating Properly

Malfunction Indicator Light Not Operating Properly

NOTE: After making any repairs, perform BODY VERIFICATION TEST  under VERIFICATION TESTS.
  1. Perform self-test on instrument cluster. Press and hold TRIP/RESET button and turn ignition on. If Malfunction Indicator Lamp (MIL) does not turn on for 4 seconds then turn off, go to step  3 . If MIL turns on for 4 seconds then turns off, go to next step.
  2. Connect scan tool to Data Link Connector (DLC) located under left side of instrument panel. See Figure . Turn ignition on. Using scan tool, check for DTC. If any DTCs are present, diagnose DTCs. See DIAGNOSTIC TROUBLE CODE IDENTIFICATION  table under SELF-DIAGNOSTIC SYSTEM. If no DTCs are present, go to next step.
  3. Turn ignition off. Remove instrument cluster and inspect MIL bulb and socket. See INSTRUMENT CLUSTER  under REMOVAL & INSTALLATION. Replace MIL bulb and socket as necessary. If MIL bulb and socket are okay, replace instrument cluster.
scientia non olet · About LEMON Manuals