LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2016 >> Volt Premier >> Repair and Diagnosis (Single Page) >> Brakes >> Traction Control >> Antilock Brake System >> Repair Instructions >> Electronic Brake Control Module with Brake Pressure Modulator Valve Replacement >> Removal Procedure

Removal Procedure

WARNING:

Refer to Brake Fluid Irritant Warning

CAUTION:

Refer to Brake Fluid Effects on Paint and Electrical Components Caution

CAUTION:

Always connect or disconnect the wiring harness connector from the EBCM/EBTCM with the ignition switch in the OFF position. Failure to observe this precaution could result in damage to the EBCM/EBTCM.

  1. Refer to High Voltage Disabling
  2. Remove Dash Upper Extension Panel Opening Cover. Refer to Dash Upper Extension Panel Opening Cover Replacement
    3. Fig 1: Radiator Surge Tank And Bracket Clip
    GM4084518Courtesy of GENERAL MOTORS COMPANY
  3. Remove Radiator Surge Tank Bracket Clip (2)
    4. NOTE:

    Do NOT disconnect the engine coolant hoses.

  4. Position aside Radiator Surge Tank (1)
    5. Fig 2: Brake Pressure Modulator Valve And Brake Pipe Fittings
    GM4084514Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Cap the brake pipe fittings to prevent brake fluid loss and contamination.

  5. Remove Brake Pipe Fitting (1) @ Brake Pressure Modulator Valve (3) (Qty: 4)
  6. Remove Brake Pipe Fitting (2) @ Brake Pressure Modulator Valve (3)
    7. Fig 3: Brake Pressure Modulator Valve And Brake Pressure Modulator Valve Primary Pipe
    GM4084517Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Cap the brake pipe fittings to prevent brake fluid loss and contamination.

  7. Remove Brake Pressure Modulator Valve Primary Pipe (1) @ Brake Pressure Modulator Valve (2)
    8. Fig 4: Brake Pressure Modulator Valve And Brake Pressure Modulator Valve Primary Pipe
    GM4084516Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Cap the brake pipe fittings to prevent brake fluid loss and contamination.

  8. Remove Brake Pressure Modulator Valve Primary Pipe (1) @ Brake Pressure Modulator Valve (2)
    9. Fig 5: Electronic Brake Control Module And Electrical Connector
    GM4084515Courtesy of GENERAL MOTORS COMPANY
  9. Disconnect Electrical Connector (1) @ Electronic Brake Control Module (2)
    10. Fig 6: Brake Pressure Modulator Valve, Bracket And Bolt
    GM4084513Courtesy of GENERAL MOTORS COMPANY
  10. Remove Brake Pressure Modulator Valve Bracket Bolt (1)
    11. NOTE:

    Protect the windshield edge before removing the component.

  11. Carefully remove the brake pressure modulator valve (3) and the brake pressure modulator valve bracket (2) from the vehicle.
  12. Remove Brake Pressure Modulator Valve Bracket. Refer to Brake Pressure Modulator Valve Bracket Replacement 
scientia non olet · About LEMON Manuals