LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Impala SS >> Repair and Diagnosis >> External Pages >> Different car >> Section 866 (Rear Suspension System) >> Repair Instructions >> Knuckle Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Upper Control Arm To Knuckle Bolt & Nut
    GM1835402Courtesy of GENERAL MOTORS CORP.
  1. Position the knuckle to the upper control arm and install the bolt and nut. Refer to Rear Axle Upper Control Arm Replacement 
  2. Install the coil spring. Refer to Coil Spring Replacement .
    3. Fig 2: Identifying Stabilizer Link To Knuckle Bolt
    GM1835394Courtesy of GENERAL MOTORS CORP.
  3. Install the stabilizer shaft to knuckle bolt. Refer to Stabilizer Shaft Replacement .
    4. Fig 3: Identifying Toe Link To Knuckle Bolt & Nut
    GM1835391Courtesy of GENERAL MOTORS CORP.
  4. Install the toe link to knuckle bolt and nut. Refer to Toe Link Replacement .
    5. Fig 4: Identifying 3 Trailing Arm To Knuckle Bolts
    GM1835385Courtesy of GENERAL MOTORS CORP.
  5. Install the (3) trailing arm to knuckle bolts (1).

    Tighten:  Tighten the trailing arm to knuckle bolts to 180 N.m (133 lb ft).

  6. Install the lower shock to knuckle bolt. Refer to Shock Absorber Replacement .
  7. Install the wheel bearing/hub assembly. Refer to Rear Wheel Bearing and Hub Replacement .
    8. Fig 5: View Of Rear Park Brake Cable Retainer Bolt
    GM1312045Courtesy of GENERAL MOTORS CORP.
  8. Install the park brake cable (1) on the trailing arm.
  9. Install the rear tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  10. Lower the vehicle.
  11. Perform a vehicle wheel alignment. Refer to Wheel Alignment Measurement .
scientia non olet · About LEMON Manuals