Installation Procedure

WARNING: This page is about a different car, the 2006 Chevrolet Monte Carlo and 2006 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing/Installing Brake Caliper Bracket & Bolts

Courtesy of GENERAL MOTORS CORP.

IMPORTANT: To ensure that the proper clamp load will be present when installed. It is imperative that the threads on the caliper bracket bolts, as well as the mounting holes in the knuckle, be cleaned of all debris and inspected before proceeding with installation.

Clean and visually inspect threads of the caliper bracket bolts (2) and mounting holes in the knuckle.
Apply THREADLOCKER, GM P/N 12345493 (Canadian P/N 10953488) or equivalent, to the threads of the brake caliper bracket bolts (2).
NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
Install the caliper bracket (1) with the bracket bolts (2).
Tighten: Tighten the caliper bracket bolts to 180 N.m (133 lb ft).
Install the front brake pads.
Install the caliper. Refer to Brake Caliper Replacement - Front .