LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2004 >> Malibu Maxx LS >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Control System (Introduction) - 2.2L (L61)) >> Repair Instructions >> Accelerator Controls Pedal Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Installing Accelerator Assembly To Vehicle
    GM1544734Courtesy of GENERAL MOTORS CORP.
  1. Install the accelerator assembly (2) to the vehicle.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the accelerator mounting bolts (1) to the accelerator bracket.

    Tighten:  Tighten the accelerator pedal nuts to 10 N.m (89 lb in).

  3. Connect the accelerator pedal position sensor electrical connector.
  4. Confirm that the accelerator sensor connector locking clip is fully secured.
  5. Verify the operation of the accelerator pedal.
scientia non olet · About LEMON Manuals