LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Cargo Extended >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Communication Devices >> Body Control Modules >> Removal & Installation >> Body Control Module >> Removal & Installation

Removal & Installation

  1. Verify type of BCM is installed. See BODY CONTROL MODULE TYPE VERIFICATION  under SELF-DIAGNOSTIC SYSTEM. Ensure replacement BCM is correct type for vehicle options and equipment. Review and record BCM information and customer feature customization preference settings prior to removal of BCM.
  2. Turn ignition switch to LOCK position. Disconnect negative battery cable. Remove insulator panel from left side of instrument panel. BCM is mounted on bracket behind glove box. See Figure . Push and release tab on bracket to release BCM from bracket. Disconnect BCM harness connectors. Remove BCM.
  3. To install, reverse removal procedure. Ensure replacement BCM is correct type for vehicle options and equipment. Program feature customization settings into replacement BCM. See ENTER FEATURE CUSTOMIZATION MODE  under PROGRAMMING.
scientia non olet · About LEMON Manuals