LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 1998 >> Metro Base >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Engine Controls - Remove/Install/Overhaul - 1.0L >> Ignition System >> Distributor >> Removal & Installation

Removal & Installation

  1. Disconnect negative battery cable. Remove distributor cap. See Figure. Mark distributor housing-to-engine position and distributor rotor-to-distributor housing position for installation reference. Disconnect distributor electrical connector. Remove 2 distributor flange bolts. Remove distributor.
  2. DO NOT rotate crankshaft with distributor removed, or reference marks will be incorrect. To install distributor, use reference marks and reverse removal procedure. Install 2 distributor flange bolts. Do not fully tighten flange bolts until timing is reset. See IGNITION TIMING in ADJUSTMENTS - 1.0L article. See TORQUE SPECIFICATIONS .
scientia non olet · About LEMON Manuals