LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2003 >> CTS Automatic >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transaxle Servicing >> Removal & Installation >> Pressure Control Solenoid >> Removal

Pressure Control Solenoid: Removal

  1. Remove the transmission oil pan and filter. See DRAINING & REFILLING  under LUBRICATION.
  2. Disconnect the electrical wiring harness connector (2) from the pressure control solenoid (1). See Fig 1.
  3. Using a small screwdriver or pick, remove the pressure control solenoid retainer from the control valve body. See Fig 2.
  4. Remove the pressure control solenoid (1) from the control valve body. See Fig 3.
  5. Remove the "O" ring seals (3-4) from the pressure control solenoid (1), ONLY if the "O" rings are cut or worn.
Fig 1: Disconnecting PCS Electrical Connector
G00178443Courtesy of GENERAL MOTORS CORP.
Fig 2: Removing PCS Retainer
G00178444Courtesy of GENERAL MOTORS CORP.
Fig 3: Removing Pressure Control Solenoid
G00178445Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals