Pump/Motor Assembly

The ABS/TCS uses an integral pump/motor assembly which is mounted to the transaxle bracket on the left side of the engine compartment. The pump/motor assembly takes brake fluid from the hydraulic unit reservoir (through the return hose), pressurizes the fluid and returns it to the accumulator (through the pressure hose). The pump/motor assembly charges the accumulator to its normal operating pressure range of 2100-2600 psi (14,480-17,930 kPa).

The pump/motor assembly is serviceable as a unit in case of failure. A separate mounting bracket is used to attach the pump/motor assembly to the transaxle bracket. Rubber insulators are also utilized to provide noise isolation. Pump motor operation is controlled by the pump motor relay, which is mounted on the right hand fender rail behind the coolant reservoir. The relay coil is energized by electrical signals from the hydraulic unit sensor block. The pump/motor assembly, pump motor relay and other underhood components. See COMPONENT LOCATIONS  .