Installation Procedure

WARNING:
Before installing the steering column lock control module to the steering column, ensure that no fasteners or debris fall into the column. If fasteners or debris fall into the column, it will cause binding of the steering system, which may result in bodily injury or death.

Steering Column Lock Control Module(3) - Install - Steering Column Lock Control Module Replacement
Steering Column(1) - Install
Steering Column Nut(1) - Install, but do NOT tighten[4x] - Use NEW nuts.
CAUTION:
Fastener Caution

Steering Column Nut(1) - Tighten in sequence[4x] 22 N.m (16 lb ft)
Connect the steering column electrical connectors.
Upper Intermediate Steering Shaft(1)@Steering Column - Install - Upper Intermediate Steering Shaft Replacement
Floor Front Air Outlet Duct - Left Side(1) - Install -
Instrument Panel Knee Bolster(1) - Install - Instrument Panel Knee Bolster Replacement
Turn Signal Switch Bracket(1) - Install NEW - Turn Signal Switch Bracket Replacement
Steering Wheel Airbag Coil(1) - Install - Steering Wheel Airbag Coil Replacement
Steering Column Lower Trim Cover(1) - Install - Steering Column Lower Trim Cover Replacement
Steering Column Upper Trim Cover(1) - Install - Steering Column Upper Trim Cover Replacement
Steering Wheel - Install - Steering Wheel Replacement
Enable the SIR System. SIR Disabling and Enabling

NOTE:

Steering Column Lock Control Module Fuse