LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2018 >> Regal Base >> Repair and Diagnosis >> Steering >> Steering Wheel And Steering Column >> Repair Instructions >> Steering Wheel Replacement

Steering Wheel Replacement

GM4421183
Callout Component Name
Preliminary Procedure 
Steering Wheel Airbag Replacement
1 Steering Wheel Bolt
CAUTION:

Refer to Fastener Caution .

CAUTION:

This vehicle is equipped with torque-to-yield or single use fasteners. Install a NEW torque-to-yield or single use fastener when installing this component. Failure to replace the torque-to-yield or single use fastener could cause damage to the vehicle or component.

Procedure

  1. Remove and DISCARD the bolt.
  2. Apply thread locking adhesive to the NEW bolt. Adhesives, Fluids, Lubricants, and Sealers 
NOTE:
  • Steering wheel bolts installed during manufacturing require higher torque efforts to remove than bolts installed after manufacturing.
  • The ONLY acceptable bit for removing and installing the steering wheel bolt is a T50 bit. Do NOT use any other size bit or a worn T50 bit or the bolt recess MAY strip and the bolt may NOT be removable.
  • If a power tool is used to remove the steering wheel bolt, the tool must have a torque rating greater than 75 N.m (55 lb ft) and both the power tool and the T50 bit MUST be positioned perpendicular to the bolt recess.

Tighten 
45 N.m (33 lb ft)
2 Steering Wheel

Procedure

  1. Disconnect the electrical connectors.
  2. Install the steering wheel bolt until 2 to 3 threads are engaged.
  3. Wiggle the steering wheel until the wheel disengages completely.
  4. Steering Wheel Bolt - Remove
  5. Steering Wheel - Remove
  6. Transfer components as necessary.
scientia non olet · About LEMON Manuals