DTC B1657: EEPROM Option Bit/CONFIG Error: Testing
- If instrument cluster system diagnostic system check was performed, go to next step. If system check was not performed, go to INSTRUMENT CLUSTER SYSTEM DIAGNOSTIC SYSTEM CHECK under SELF-DIAGNOSTIC SYSTEM.
- Connect scan tool to Data Link Connector (DLC). DLC is located below left side of instrument panel, to right of steering column. See Figure . Turn ignition on. Retrieve DTCs. If DTC is current, go to next step. If DTC is history, recheck system.
- Perform the setup procedure for the module if required. See PROGRAMMING . Replace the IPC. See REMOVAL & INSTALLATION . Go to next step.
- Use the scan tool in order to clear the DTCs. Operate the vehicle. If DTC resets, go to step 2 . If DTC does not reset, system is okay.