Encode/program control unit(s)
Precondition
Component has been replaced.
NOTE:
TECHNICAL INFORMATION
Use the most recent software version to prevent faults during programming/coding.
Battery voltage must not drop below 13.0 V during programming.
Only use chargers recommended by BMW for low-voltage vehicle electrical systems.
Use the most recent software version to prevent faults during programming/coding.
Battery voltage must not drop below 13.0 V during programming.
Only use chargers recommended by BMW for low-voltage vehicle electrical systems.
- Connect the battery charger to the vehicle.
- Connect the programming system with the vehicle.
- Determine the action plan.
- Accept and fully process the action plan.
- Depending on the reworking list, connect the workshop system to the vehicle if necessary.
- Carry out vehicle test.
- Delete the fault memory.
- Note the information on programming in the workshop system and the relevant information in the user documentation.
- Wait until programming/coding has been completed.
- Disconnect the programming system from the vehicle.
- Disconnect the battery charger from the vehicle.